Care & Maintenance

The Penny Test and Beyond: How to Check Your Tread Before the Cold Weather Hits

Learn to check tire tread depth in your driveway with a penny, why under 2/32 of an inch fails a Maryland safety inspection, and when to replace tires.

XFacebook
Isometric illustration of a penny standing in a worn tread groove, head fully showing

Tread is what pushes water and slush out from under a tire. Once it wears down, that job gets harder, and the first cold, wet morning is a bad time to find out. This is a ten-minute check you can do in the driveway, with a coin, before the weather turns.

The Penny Test, Step by Step

  1. Take a Lincoln penny and hold it so Lincoln's head points down.
  2. Push it into a groove between the tread ribs, near the center of the tire.
  3. Look at his head. If you can see the whole head above the tread, the tread is at about 2/32 of an inch or below, and the tire needs to be replaced.
  4. Repeat in several places, on the inside, center and outside of the tire, then on the other three tires.

The penny test is quick but rough. A tread depth gauge is more precise and costs very little. If you have one, use it, and take a few readings per tire.

Frequently Asked Questions

Place a Lincoln penny head-first into a groove. If the whole head is visible, the tread is at about 2/32 of an inch or less and the tire should be replaced. Test in several places on each tire.

Ready for a Fresh Set?

Browse the tire catalog or book an appointment and we will check your tread before you decide.

Book a Visit

Credits